Home ReviewsRefund
Home/Cadillac/Eldorado/Cadillac Eldorado X (1992-2002)/Repair manual/Mechanical/Removal & Installation (Left)
Contents Wiring diagrams Section: Mechanical All sections

Removal & Installation (Left) Cadillac Eldorado X

Mechanical ~152 words
  1. Remove radiator cradle beauty panel. Remove air cleaner assembly. Disconnect left and right engine torque strut rods, and position them aside. Remove engine cooling fans. Support engine from above using Engine Support Fixture (J-28467-A). Raise vehicle on hoist.
  2. Remove 2 nuts securing motor mount to engine cradle. Remove 2 bolts securing motor mount bracket to crankcase. Remove 2 bolts securing motor mount bracket to cylinder head. Remove 2 nuts securing motor mount to motor mount bracket.
  3. Disconnect exhaust "Y" pipe from catalytic converter. Position and support catalytic converter aside. Lower vehicle. Raise engine by adjusting engine support fixture. Remove motor mount and bracket. Raise vehicle. Remove 4 bolts securing rear alternator bracket. Remove 2 bolts securing exhaust crossover pipe to manifold. Disconnect oxygen sensor connector.
  4. Remove nuts, exhaust manifold, and gasket. Discard gasket if damaged. To install, reverse removal procedure. Tighten fasteners to specification. See «TORQUE SPECIFICATIONS»(ref-54836-S33559028762001011700000) table.

More articles — Engine Mechanical - 4.6L V8 - Vins Y & 9