2.5L - Engine Assembly - Engine Code(s): Cepb (Coupe): Adjustments Audi TT 8J facelift

SUBFRAME MOUNT, CHECKING ADJUSTMENT

Special tools and workshop equipment required

1. Gauge T40226

Procedure

Remove the engine cover -1- upward -arrows-.

Remove the air filter housing, refer to Removal and Installation .

Open wiring router bracket -arrows-.

Cut the cable ties and push the cables aside.

Remove the wiring guide.

Attach and tighten the T40226 to the bolt head for the left transmission mount.

Lock the bridge for the T40226 on the casting edge -arrow- for the transmission as shown in the illustration.

1. The gap between the socket wrench and the transmission mount must be the same distance in the front and rear.
2. Dimension -x- rear = dimension -x- front (parallel) or
3. Dimension -x- rear = dimension -x- front = "0" (without gap).

Check the installed position on the engine mount

1. There must be a distance -a- = at least 9 mm from the support arm to the engine mount.

Note. The dimension -a- can be checked for example using a 9 mm diameter drill bit.

If it is measured to be a smaller distance, adjust the subframe mount, refer to SUBFRAME MOUNT, ADJUSTING .