Continuously Variable Transmission: Overhaul Subaru Outback BR

DISASSEMBLY

1. Remove the dust cover from extension case.
2. Remove the extension case oil seal from the extension case.

ASSEMBLY

1. Press-fit the dust cover into extension case.
2. Install the extension case oil seal to extension case. ST 498057300 INSTALLER

1. Install the reverse brake. Ref. to «ASSEMBLY»(ref-371903-S14571259312010091900000) , Reverse Brake Assembly.
2. install all plugs to intermediate case. Tightening torque: 25 N.m (2.5 kgf-m, 18.4 ft-lb) NOTE: Use new O-rings.
3. Install the CVTF filler plug. NOTE: Replace the gasket of CVTF filler plug with a new part after installing the transmission assembly to vehicle and adjusting CVTF fluid.

1. Install the plugs. NOTE: Use new O-rings. Apply CVTF to the O-ring. Tightening torque: 25 N.m (2.5 kgf-m, 18.4 ft-lb)
2. Using TORX® E16, install the center support COMPL. Tightening torque: 21.5 N.m (2.2 kgf-m, 15.9 ft-lb)
3. Install the oil pump chain cover. Ref. to «INSTALLATION»(ref-371903-S40227833602010091900000) , Oil Pump Chain.