Special tools
[1] ball-joint extractor (-).0336-G
Removing
Remove
- The air cleaner
- The connector (1) from the bracket (2)
Place the gear selection lever in position N
Unclip the selector lever (3) (using tool [1])
Disconnect the connector (1)
Remove: the air cleaner
Place the gear selection lever in position N
Disconnect the connector (1)
Unclip the selector lever (2) (using tool [1])
Unclamp the harness (4)
Remove the rod (5)
Remove the multifunction switch (6)
WarningThe adjusting plate (7) on the automatic gearbox must never be removed, as if it is the correlation between the automatic gearbox selector position and the electrical reading cannot be guaranteed
Remove the air inlet hose
Place the gear selection lever in position N
Unclip the gear change cable (using tool [1])
Disconnect the connector (1)
Unclamp the harness
Remove
- The nut (2)
- The push rod (4)
- The bolts (3)
- The multi-function switch (5)
WarningDo not remove the plate (6)
Refitting
NoteThe switch is positioned by inserting the centralising pin in the adjusting plate
Precautions to be taken
- Ensure that the lever is in position N
- If the switch is changed, it is delivered positioned at N
Refit
- The switch (tightening torque to 1.0 da.Nm)
- The selector rod (tightening torque to 2.1 da.Nm)
Tighten the securing nut to a torque of 2.1 m.daN
WarningSupport the selector rod while tightening (risk of the slide valve in the hydraulic block being broken and not being in position N in the event of rotation)
Clip the electrical harness
Refasten the connector
Proceed in the reverse order to removal
Check that the lever position corresponds to the fascia display