Removing
Remove the headlining with flaps
Remove the mountings (1)
Open the front door
Remove the mountings (2)
Open the upper rear indexing clip
Tilt the windscreen pillar trim (3) forwards to detach the windscreen pillar exterior seal (4)
Place a screwdriver blade in the mounting pin (5) and pivot it
- Towards the front of the vehicle (on the left-hand side)
- Towards the rear of the vehicle (on the right-hand side)
Unclip the windscreen pillar trim (3) by pulling it
Remove the windscreen pillar trim (3)
Tighten the 2 mounting pin (5) clipping tabs to detach the pin
Remove the mounting pin (5)
Refitting
WarningEnsure that the sliding inserts are present on the stamped sections (H)
Reposition the exterior seal (4) on the flange between the windscreen and the windscreen pillar
Lock the mounting pin (5) on the windscreen pillar trim (3)
WarningReplacement of the windscreen pillar trim: fit the windscreen pillar trim with foam blocks as indicated above
Clip the windscreen pillar trim (3)
- On the front wing hole, using the mounting pin (5)
- At the upper rear section, using the indexing clip
Position the trim mountings without tightening them
Seat the windscreen pillar trim (3) and tighten the mountings in the following order A - B - C - D - E - F - G
Continue the fitting operations in the reverse order to removal