Table 7, F7: Programming
Note:
If a new control unit or a control unit from another vehicle is installed in a vehicle, the control unit must be re - programmed.
Observe the notes listed below carefully, since otherwise Motronic, automatic transmission and ABS - 2SH are not properly matched:
When asked whether the correct Motronic control unit is installed, proceed according to the following information or the latest "Technical Information Bulletins":
The following control unit is currently used in Omega - B vehicles with X 25 XE engine:
Opel Part No.: 90457097
Alpha Code: PR
The following control unit is currently used in Omega - B vehicles with X 30 XE engine:
Opel Part No.: 90457098
Alpha Code: PS
When asked whether the correct AT control unit is installed, proceed according to the following information or the latest "Technical Information Bulletins":
The following control unit is currently used in Omega - B vehicles with X 20 SE / X 20 XEV / X 25 XE / X 30 XE engine:
Opel Part No. 96017168
Alpha Code: KT
The following control unit is currently used in Omega - B vehicles with 25 DT engine:
Opel Part No.: 96016632
Alpha Code: HU
When asked whether the correct ABS - 2SH (with TC) control unit is installed, proceed according to the following information or the latest "Technical Information Bulletin":
At present, the OMEGA - B with the X 25 XE / X 30 XE engine is equipped with the following control unit:
Opel Part No.: 90447587
Alpha Code: XD
Important:
In the most unfavourable circumstances, incorrect programming can lead to drivability problems (jerking, driving off problems, etc. ).