DTC p0563
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC P0563 :
System Voltage High
Diagnostic Fault Information
| Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
| IGN | P0562 | P0562 | -- | -- |
| Ground | -- | P0562 | -- | -- |
Circuit/system Description
The engine control module (ECM) monitors the system voltage to ensure that the voltage stays within the proper range. Damage to components, and incorrect data may occur when the voltage is out of range.
Conditions for Running the DTC
| • | The vehicle speed is above 8 km/h (5 mph). |
| • | The system voltage is between 9.5-18 volts. |
Conditions for Setting the DTC
The ECM detects a system voltage above 16 volts for less than 1 second.
Action Taken When the DTC Sets
The instrument panel cluster (IPC) illuminates the charge indicator.
Conditions for Clearing the DTC
DTC P0563 is a C type DTC.
Diagnostic Aids
| • | A possible cause of this DTC could be overcharging with a battery charger or jump starting. |
| • | A high voltage value in multiple modules indicates a concern in the charging system. |
Reference Information
Schematic Reference
Engine Controls Schematics for the 2.0L engine.
Connector End View Reference
Component Connector End Views
Description and Operation
Charging System Description and Operation
Electrical Information Reference (Except Opel Gt)
| • | Circuit Testing |
| • | Connector Repairs |
| • | Testing for Intermittent Conditions and Poor Connections |
| • | Wiring Repairs |
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/system Verification
- Engine running measure and record the voltage at the battery terminals. Verify that the battery voltage is 12.6-15.5 volts
- Engine running, observe the scan tool ECM Ignition 1 signal parameter. The voltage should be between 12.5 and 15.5 volts.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ECM replacement, setup, and programming.