| Engine | X 16 SZR | Z 16 SE | |
|---|---|---|---|
| No. of cylinders/ layout | 4 in line | ||
| No. of valves | 8 | ||
| Displacement | cm 3 | 1598 | |
| Bore diameter | mm | 79 | |
| Stroke | mm | 81.5 | |
| Power output | kW / rpm | 55 / 5200 | 62 / 5400 |
| Torque | Nm / rpm | 128 / 2800 | 138 / 2600 |
| Compression | 9.6 : 1 | ||
| Exhaust emissions standard | 96/69/EC, D3 | 98/69/EC, D4, Euro 3 | |
Contents
Wiring diagrams Section: OHC Petrol Engine- How to Check and Measure the Cylinder Head and Attaching Parts (Survey)
- How to Check the Cylinder Head Height
- How to Check for Plane Surface the Cylinder Head
- How to Measure the Valve
- How to Check the Inner Diameter of Valve Guide
- Valve Stem Play, Determine
- How to Check the Installation Height of Valves
- How to Check the Installation Height of Valve Guide
- Battery / Starter, Petrol (Current Measurement)
- Battery / Starter (Voltage Measurement)
- How to Overhaul the Cylinder Head
- Cylinder Head, Attach to Assembly Tool Set KM-6215
- Cylinder Head, Disassemble
- How to Remove the Valves
- Engine, Engine Attaching Parts X 16 SZR Ohc-I Petrol Engine
- Compression 4-cylinder, Unsynchronised
- Valve Seat, Cut (In Cylinder Head)
- Valve Guide, Ream
- Crankshaft Impulse Sensor, Petrol and Z19DT
- Valve, Grind
- Valve, Grind In
- How to Replace the Valve Stem Seals
- How to Assemble the Cylinder Head
- Cylinder Head Machining Special Tools
- Measuring Oil Consumption
- Exhaust Gas Recirculation Valve, Multec S and Motronic (MY 2000)
- Ignition, Secondary
- Injector (Multi-Point Fuel Injection), All Except Z22YH
- Injector (Single-Point Fuel Injection)
- Intake Manifold Absolute Pressure (MAP) Sensor
- Engine Identifier
- Knock Sensor
- Engine and Performance Values - Astra-G
- Oxygen Sensor, Multec-F
- Throttle Valve Potentiometer, Multec (MY 2000)
- Ignition, Primary, Frontera-B Y22SE, Corsa-C Z16SE
- Engine Values and Performance Values Astra-G
- Engine, Engine Attaching Parts Ribbed V-Belt Tensioner
- All OHC and Dohc-Ii Petrol Engines
- Engine, Engine Attaching Parts Electronic Immobiliser with Transponder
- Engine, Engine Attaching Parts Layout in the Vehicle
- Engine, Engine Attaching Parts Function
- Engine, Engine Attaching Parts Functional Diagram
- Engine, Engine Attaching Parts Car Pass
- Engine, Engine Attaching Parts Description of Individual Components Transponder
- Introduction
- Engine, Engine Attaching Parts Immobiliser Control Unit
- Engine, Engine Attaching Parts System Programming
- Loss of Oil from Oil Pump Seal and Exhaust Pipe Becoming Detached
- OHC I Petrol Engine - Z 16 XE - All Vehicle Types
- Engine Compartment Survey - Z 16 SE - All Vehicle Types
- Cylinder Head - Z 16 SE - All Vehicle Types
- Cylinder Head Gasket - Z 16 SE - All Vehicle Types
- Crankshaft - Z 16 SE - All Vehicle Types
- Piston - Z 16 SE - All Vehicle Types
- Intake Module - Z 16 SE - All Vehicle Types
- Dis- Ignition Module - Z 16 SE - All Vehicle Types
- Block Diagram - Z 16 SE - All Vehicle Types
- Engine Driveability - Bad Idling
- Cracks in Intake Manifold Gasket
- Engine - Spark Plugs Wet
- Toothed Belt Diagnosis - Possible Causes and Remedys
- Toothbelt - Service Intervall Overview
- Engine - Broken Timing Chain
- Cylinder Head - Programming Option "Old" and "New" Cylinder Head
- Spark Plug Damages - Possible Causes and Failure Modes
- OHC I Petrol Engine (X 16 SZR, Z 16 SE) (Engine Identification/engine Number)
- How to Check the Ribbed V-Belt Tension
- How to Check the Compression
- How to Check the Pressure Loss
- How to Measure the Oil Temperature
- How to Check the Oil Pressure
- How to Measure the Oil Consumption
- How to Check the Timing
- How to Adjust the Timing
- How to Check the Toothed Belt Tension
- How to Adjust the Toothed Belt Tension
- Illustration (X 16 SZR)
- How to Remove and Install the Ribbed V-Belt Tensioner
- How to Remove and Install the Toothed Belt Cover, Upper Part
- How to Remove and Install the Toothed Belt Cover, Lower Part
- How to Remove and Install the Toothed Belt
- How to Remove and Install the Toothed Belt Tension Roller
- How to Replace the Seal Ring in Front Camshaft Housing
- How to Remove and Install the Rear Toothed Belt Cover
- How to Replace the Seal Ring in Rear Camshaft Housing
- How to Remove and Install (X 16 SZR) the Exhaust Manifold
- How to Remove and Install (X 16 SZR) the Intake Manifold
- How to Remove and Install the Heat Shields
- How to Remove and Install (Cylinder Head Installed) the Camshaft and Cam Follower
- How to Replace (Cylinder Head Installed) the Hydraulic Valve Lifter
- How to Remove and Install (Cylinder Head Removed) the Camshaft
- How to Check for Plane Surface the Camshaft Housing
- How to Replace the Camshaft Housing
- How to Remove and Install the Cylinder Head
- How to Remove and Install the Drive Disc
- How to Remove and Install the Flywheel
- How to Replace the Seal Ring - Rear Crankshaft
- How to Remove and Install the Piston with Con-Rod
- How to Remove and Install the Piston Rings
- How to Replace the Con-Rod Bearing
- How to Check (Determine Bearing Play with Plastigage) the Con-Rod Bearing Play
- How to Check (Determine Bearing Play with Micrometer and Inside Micrometer) the Con-Rod Bearing Play
- How to Replace the Piston
- How to Remove and Install the Crankshaft
- How to Check the Crankshaft (Crankshaft Longitudinal Play, Check)
- How to Check (Determine Bearing Play with Plastigage) the Crankshaft Bearing Play
- How to Check (Determine Crankshaft Bearing Play Using External Micrometer and Inside Micrometer) the Crankshaft Bearing Play
- How to Replace the Oil Filter
- How to Replace the Bypass Valve
- How to Replace the Seal Ring - Oil Pump, Replace / Front Seal Ring - Crankshaft
- How to Remove and Install the Oil Pan
- How to Remove and Install the Dynamic Oil Level Control
- How to Remove and Install the Oil Pump
- How to Check the Oil Pump
- How to Remove and Install the Safety Valve
- How to Remove and Install the Oil Intake Pipe
- How to Remove and Install the Oil Baffle Plate
- How to Remove and Install the Oil Pressure Switch
- How to Remove and Install the Oil Dipstick Guide Tube
- Cooling System, Charge and Bleed
- How to Check for Leaks the Cooling System
- How to Check for Leaks the Engine ((CO Content in Cooling System))
- How to Remove and Install (With Air Conditioning) the Fan Motor
- How to Remove and Install the Auxiliary Fan Motor
- How to Remove and Install the Radiator (With Air Conditioning)
- How to Remove and Install the Thermostat
- How to Remove and Install the Coolant Pump
- How to Remove and Install the Coolant Pipe
- How to Remove and Install the Control Unit - Cooling Module
- How to Remove and Install the Front Engine Damping Block
- How to Remove and Install the Rear Engine Damping Block
- How to Remove and Install the Engine Damping Block, Left
- How to Remove and Install the Engine Damping Block, Right
- How to Remove and Install the Engine
- How to Repair Using Short-Block the Engine
- Engine Compartment Survey (X 16 SZR) - Multec
- How to Check (X 16 SZR) the Intake Air Preheating
- How to Remove and Install (X 16 SZR) the Throttle Valve Injection Housing
- How to Remove and Install (X 16 SZR) the Throttle Valve Injection Housing, Upper Part
- How to Remove and Install (X 16 SZR) the Injectors
- How to Check (X 16 SZR) the Reference Gap Between Crankshaft Pulse Pickup and Increment Disc
- How to Remove and Install the Fuel Pump Relay
- How to Remove and Install the Accelerator Pedal
- How to Remove and Install the Immobiliser with Immobiliser Control Unit Transponder
- Special Service Tools
- Sealants, Lubricants and Locking Agents
- Specifications
- Checking and Adjustment Values
- Ribbed V-Belt - Toothed Belt
- Coolant Circuit
- Oil Circuit
- Cylinder Head
- Crank Drive, Cylinder Block
- Engine Management
- Recommended Torque Values
- How to Check for Plane Surface the Cylinder Block
- How to Check the Crankshaft Out-Of-Round
- How to Remove and Install the Engine Vent Flange
- Illustration (Z 16 SE)
- How to Remove and Install (Z 16 SE) the Exhaust Manifold
- How to Remove and Install (Z 16 SE) the Intake Manifold
- Engine Compartment Survey (Z 16 SE) - Multec S
- How to Remove and Install (Z 16 SE) the Camshaft Sensor
- How to Check (Z 16 SE) the Fuel Pressure
- How to Remove and Install (Z 16 SE) the Intake Air Temperature Sensor
- How to Remove and Install (Z 16 SE) the Coolant Temperature Sensor
- How to Remove and Install the Accelerator Pedal Module
- How to Remove and Install the Attaching Parts - Cylinder Head
- How to Remove and Install the Spark Plugs
- ABS 5.3
- ABS 5.3/TC/ESP
- ABS 5/TC, ABS 5.3/TC
- Accessories
- Additional Lighting
- Adhesive Foiles
- Air Conditioning
- Airbag
- Antenna
- Anti-Theft Warning System-M
- Automatic Transmission Front Wheel Drive
- Battery
- Body Equipment
- Brake Hydraulics, Brake Lines
- Brakes
- Car Level Control
- Central Door Locking System
- Central Electrics
- Central Locking with Atws (Electronic)
- Check Control
- Clutch
- Clutch and Transmission
- Cng
- Communication / Navigation
- Connector pinouts
- Cooling System
- Corrosion Protection
- Diesel Engine
- DOHC Diesel Engine
- DOHC Petrol Engine
- Ecc Electronic Climate Control
- Ehps - Electrical Hydraulic Power Steering
- Electrical Equipment and Instruments
- Electrical Window Winders
- Electronic Cruise Control
- Engine and Engine Aggregates
- Engine Electrics
- Exhaust System
- Fittings, Hinges, Locks
- Folding Roof
- Frame
- Front End
- Front Wheel Brake
- Front Wheel Suspension
- Front Wheel Suspension, Wheels and Tyres
- Fuel and Exhaust System
- Fuel Injection Systems
- Fuel System
- Fuse Box
- General Vehicle Information
- Glass, Window Guides, Window Winders
- Graphic Info Display
- Headlamps, Lamps and Horn
- Heating, Ventilation
- Heating, Ventilation, Air Conditioning (HVAC)
- Immobiliser
- Instruments, Telltales
- Maintenance, Body and Chassis Sheet Metal Parts, Frame
- Manual Transmission Front Wheel Drive
- Mid (Multi Info Display)
- Multitimer
- OHC Petrol Engine
- Other Accessories
- Outside Rear View Mirror
- Paint
- Painting Repair Operations
- Painting Repair System
- Radiator Grille
- Radio
- Radio Interference Suppression
- Rear Axle and Rear Wheel Suspension
- Rear Axle Front Wheel Drive
- Rear Wheel Brake
- Roof Luggage Carrier (Railing)
- Seat Heating Systems
- Seats, Upholstery, Inner Trim Panels
- Secondary Air Injection
- Service Brake, Parking Brake
- Sheet Metal Parts (Bolted)
- Sheet Metal Parts (Cement and Seal)
- Sheet Metal Parts (Welded)
- Sliding Roof
- Steering
- Steering Gear
- Steering Intermediate Shaft
- Steering Linkage
- Steering Wheel - Steering Column
- Switches, Control Unit, Relays, Ignition Lock
- TID (Triple Info Display)
- Trailer Hitch
- Trim Panels, Radiator Grille, Spoiler
- Trim Strips, Lettering, Coverings
- Turbo-Charging
- Wheels and Tyres
- Windscreen Wash/wipe System, Heated Screen
- Wiring Harnesses
- Xenon Control Unit (Headlamp Range Control)