POWER WINDOW OPERATION
- Main power window and door lock/unlock switch can open/close all windows.
- Front and rear power window switches can open/close the corresponding windows.
POWER WINDOW AUTO-OPERATION (FRONT DRIVER SIDE)
- AUTO UP/DOWN operation can be performed when main power window and door lock/unlock switch turns to AUTO.
- Encoder continues detecting the movement of power window motor and transmits to power window switch as the encoder pulse signal while power window motor is operating.
- Power window switch reads the changes of encoder signal and stops AUTO operation when door glass is at fully opened/closed position.
- Power window motor is operable in case encoder is malfunctioning.
RETAINED POWER OPERATION
Retained power operation is an additional power supply function that enables power window system to operate for 45 seconds even when power switch is turned OFF.
OPERATION CONDITION
- When front door glass (driver side) AUTO-UP operation is performed (anti-pinch function does not operate just before the door glass closes and is fully closed).
Note. Depending on environment and driving conditions, if a similar impact or load is applied to the door glass, it may lower.
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL: Description
If any of the following work has been done Initial setting is necessary.
- Power supply to the main power window and door lock/unlock switch or power window motor is cut off by the removal of battery terminal or the battery fuse is blown.
- Disconnection and connection of main power window and door lock/unlock switch harness connector.
- Removal and installation of motor from regulator assembly.
- Operation of regulator assembly as an independent unit.
- Removal and installation of glass.
- Removal and installation of door glass run.
The following specified operations can not be performed under the non-initialized condition.
- Auto-up operation
- Anti-pinch function
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: Description
Refer to " ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL: DESCRIPTION ".
Description
Front power window motor RH will be operated if front power window switch RH is operated.
Rear power window motor will be operated if rear power window switch is operated.
DRIVER SIDE: Description
Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch.
PASSENGER SIDE: Description
Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch or front power window switch (passenger side).
REAR LH: Description
Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch or rear power window switch LH.
REAR RH: Description
Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch or rear power window switch RH.
Detects condition of the front power window motor LH operation and transmits to main power window and door lock/unlock switch as pulse signal.
Power is supplied to the main power window and door lock/unlock with BCM control.
WITHOUT INTELLIGENT KEY: Description
Detects door open/close condition.