Removal & Installation - Automatic Transmission: Overhaul MINI Cooper I

THROTTLE ASSEMBLY

Note. A faulty throttle valve causes the adaptation values stored in the DME control unit to be modified. These adaptation values must be reset after the throttle valve has been replaced.

1. Read out fault memory of DME control unit. Check stored fault messages. Switch off ignition.
2. Release clamp (1). (Scheme 37) Detach intake fitting from intake filter housing. Loosen screws (2). Release cable holders (3 and 4). Remove intake filter housing.
3. Release clip (3). (Scheme 38) Detach vent hose (4) from intake fitting (2). Release clamps (1). Detach intake fitting (2) from throttle assembly and intake filter housing.
4. Unlock line of tank venting valve on throttle valve assembly and disconnect. (Scheme 39) Unlock plug (1) and remove. Loosen screws (2). Remove throttle valve assembly (3).
5. Replacement only: Delete adaptation values and reset. Connect diagnosis system: Diagnosis Model DME engine Control unit function DME 2000 Component activation Reset adaptation values Electronic throttle Now clear the fault memory.
6. To install, reverse removal procedure. Replace sealing ring (1). (Scheme 40) Tighten fasteners to specification. See «TORQUE SPECIFICATIONS»(ref-170110-S35168387042004123000000).

Scheme 37

Scheme 38

Scheme 39

Scheme 40