Home ReviewsRefund
Home/Lexus/RX/Lexus RX II рестайлинг (2006-2009)/Repair manual/Automatic HVAC System/Air Conditioning: Removal & Installation
Contents Section: Automatic HVAC System All sections

Air Conditioning: Removal & Installation Lexus RX II рестайлинг

Automatic HVAC System ~395 words

INSTALLATION

  1. INSTALL HEATER WATER PUMP ASSEMBLY Install the heater water pump assembly with the 2 bolts. Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) Install the 2 heater water hoses with the 2 clips. Engage the 2 clamps to install the harness protector
  2. INSTALL W/CONVERTER INVERTER ASSEMBLY (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  3. INSTALL INVERTER BRACKET NO.4 (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  4. INSTALL RELAY BLOCK ASSEMBLY ENGINE ROOM (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  5. REMOVE INVERTER COVER (See «REMOVAL»(ref-282981-S11649468332008041400000) )
  6. CONNECT NO.3 WIRE FRAME (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  7. CONNECT MG ECU CONNECTOR (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  8. CONNECT ENGINE WIRE NO.4 (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  9. CHECK HIGH VOLTAGE CABLE CONNECTION (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  10. INSTALL INVERTER COVER (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  11. INSTALL POWER STEERING ECU BRACKET (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  12. CONNECT WATER HOSE (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  13. INSTALL INVERTER RESERVE TANK SUB-ASSEMBLY (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  14. CONNECT ENGINE ROOM WIRE NO.2 (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  15. CONNECT CIRCUIT BREAKER SENSOR NO.1 (See «INSTALLATION»(ref-282981-S39507698812008041400000) )
  16. INSTALL POWER STEERING ECU ASSEMBLY (See «INSTALLATION»(ref-283001-S19223578562008041400000) )
  17. INSTALL INVERTER BRACKET NO. 5 (See «INSTALLATION»(ref-283001-S19223578562008041400000) )
  18. INSTALL AIR CLEANER W/ RESONATOR (See «INSTALLATION»(ref-282995-S10591638162008041400000) )
  19. INSTALL AIR CLEANER CAP W/ INLET (See «INSTALLATION»(ref-282992-S11458015172008041400000) )
  20. INSTALL COOL AIR INTAKE DUCT SEAL (See «INSTALLATION»(ref-282992-S11458015172008041400000) )
  21. INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER (See «INSTALLATION»(ref-282992-S11458015172008041400000) )
  22. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY (See «INSTALLATION»(ref-282998-S28619435412008041400000) )
  23. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
  24. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH (See «INSTALLATION»(ref-282998-S28619435412008041400000) )
  25. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH (See «INSTALLATION»(ref-282998-S28619435412008041400000) )
  26. INSTALL ENGINE ROOM COVER SIDE (See «INSTALLATION»(ref-282992-S11458015172008041400000) )
  27. INSTALL ENGINE ROOM SIDE LH COVER NO.2 (See «INSTALLATION»(ref-282992-S11458015172008041400000) )
  28. INSTALL SERVICE PLUG GRIP (See «INSTALLATION»(ref-283000-S32862437702008041400000) )
  29. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
  30. ADD COOLANT (for Inverter) (See «REPLACEMENT»(ref-282994-S13776237332008041400000) )
  31. ADD COOLANT (for Engine) (See «COOLANT (for Engine)»(ref-282997-S07256750572008041400000) )
  32. INSPECT FOR COOLANT LEAKS (for Inverter)
  33. INSPECT FOR COOLANT LEAKS (for Engine) (See «COOLING SYSTEM»(ref-282997-S29273365312008041400000) )
  34. PERFORM INITIALIZATION NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal. (See «INITIALIZATION»(ref-282976-S16822617822008041400000) )
  1. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY Install the air conditioner amplifier assembly with the 2 nuts.
  2. INSTALL HYBRID VEHICLE CONTROL ECU (See «INSTALLATION»(ref-282981-S19785359542008041400000) )
  3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (See «INSTALLATION»(ref-282983-S36897133672008041400000) )
  4. INSTALL INSTRUMENT PANEL UNDER COVER NO.2 SUB-ASSEMBLY (See «INSTALLATION»(ref-282983-S36897133672008041400000) )
  5. INSTALL SIDE TRIM RH SUB-ASSEMBLY
  6. INSTALL FRONT DOOR SCUFF PLATE RH
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
  8. PERFORM INITIALIZATION NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal. (See «INITIALIZATION»(ref-282976-S16822617822008041400000) )

More articles — Air Conditioning