Home ReviewsRefund
Home/Honda/Crosstour/Honda Crosstour I (2009-2012)/Repair manual/Testing & Diagnostics/DTC P0369: CMP Sensor Circuit Intermittent Interruption
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0369: CMP Sensor Circuit Intermittent Interruption Honda Crosstour I

Testing & Diagnostics ~365 words

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION (+).

  1. Turn the ignition switch to ON (II).
  2. Clear the DTC with the HAS.
  3. Start the engine, and let it idle for 10 seconds.
  4. Monitor the OBD STATUS for DTC P0369 in the DTC's MENU with the HAS. Does the HAS indicate failed? YES -Go to step 6 . NO -If the HAS indicates PASSED, go to next step. If the HAS indicates NOT COMPLETED, keep idling until the results come back on.
  5. Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters: ENGINE SPEED VSS
  6. Monitor the OBD STATUS for DTC P0369 in the DTC's MENU with the HAS. Does the HAS indicate FAILED? YES -Go to next step. NO -If the HAS indicates PASSED, intermittent failure, connections or loose terminals at the CMP sensor and the PCM, if the HAS indicates NOT COMPLETED, go to 5 and recheck.
  7. Check for poor connections or loose terminals at these locations: CMP sensor PCM Engine ground Body ground Are the connections and terminals OK? YES -Go to next step. NO -Repair the connections or terminals, then go to step 11 .
  8. Check for damage to the front camshaft pulley (CMP sensor pulse plate) (see «CMP SENSOR REPLACEMENT»(ref-360080-S26507110752010042600000) (+). Is the pulse plate damaged? YES -Replace the front camshaft pulley (CMP sensor pulse plate) (see «CAMSHAFT REPLACEMENT»(ref-360071-S31999220212010042600000) (+) then go to step 11 . NO -Go to next step.
  9. Turn the ignition switch to LOCK (0).
  10. Replace the CMP sensor (see «CMP SENSOR REPLACEMENT»(ref-360080-S26507110752010042600000) (+).
  11. Turn the ignition switch to ON (II).
  12. Reset the PCM with the HAS.
  13. Do the PCM idle learn procedure (see «PCM IDLE LEARN PROCEDURE»(ref-360079-S22847966492010042600000) (+).
  14. Start the engine, and let it idle for 10 seconds.
  15. Check for Pending or Confirmed DTCs with the HAS. Is DTC P0369 indicated? YES -Check for poor connections or loose terminals at the CMP sensor and the PCM, then go to step 1 . NO -Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.

More articles — Pgm-Fi System (V6)