Home ReviewsRefund
Home/Honda/Accord/Honda Accord VII (2002-2006)/Repair manual/Testing & Diagnostics/DTC P0116: ECT Sensor 1 Range/Performance Problem (2005-200…
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0116: ECT Sensor 1 Range/Performance Problem (2005-2007 models) Honda Accord VII

Testing & Diagnostics ~355 words

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

  1. Turn the ignition switch ON (II).
  2. Check ECT SENSOR 1 in the DATA LIST with the HDS. Is about 176°F (80°C) or more, or 0.78 V or less indicated? YES - Go to step 6 . NO - Go to step 3.
  3. Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.
  4. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until the radiator fan comes on, then let it idle.
  5. Check ECT SENSOR 1 in the DATA LIST with the HDS. Does ECT SENSOR 1 change 18°F (10°C) or more? YES - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the ECM/PCM. NO - Go to step 11 .
  6. Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.
  7. Turn the ignition switch OFF.
  8. Open the hood, and let the engine cool for 3 hours.
  9. Turn the ignition switch ON (II).
  10. Check ECT SENSOR 1 in the DATA LIST with the HDS. Does ECT SENSOR 1 change 18°F (10°C) or more? YES - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the ECM/PCM. NO - Go to step 11.
  11. Turn the ignition switch OFF.
  12. Replace ECT sensor 1 (see «ECT SENSOR/ECT SENSOR 1 REPLACEMENT»(ref-220840-S15461657522006022100000) ).
  13. Turn the ignition switch ON (II).
  14. Reset the ECM/PCM with the HDS.
  15. Do the ECM/PCM idle learn procedure (see «ECM/PCM IDLE LEARN PROCEDURE»(ref-220843-S14332728472006022100000) ).
  16. Check for Temporary DTCs or DTCs with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P0116 is indicated, check for poor connections or loose terminals at ETC sensor 1 and the ECM/PCM, then go to step 1 . If any other Temporary DTSs or DTCs are indicated, go to the indicated «DTC TROUBLESHOOTING»(ref-220840-S22832464282006022100000) . NO - Troubleshooting is complete.

More articles — Pgm-Fi System (V6)