Home ReviewsRefund
Home/Honda/Accord/Honda Accord VII (2002-2006)/Repair manual/Testing & Diagnostics/DTC P2108: Throttle Actuator Control Module Problem
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P2108: Throttle Actuator Control Module Problem Honda Accord VII

Testing & Diagnostics ~129 words

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

  1. Turn the ignition switch ON (II).
  2. Clear the DTC with the HDS.
  3. Turn the ignition switch OFF.
  4. Turn the ignition switch ON (II).
  5. Check for Temporary DTCs or DTCs with the HDS. Is DTC P2108 indicated? YES - Substitute a known-good throttle actuator control module (see «APP SENSOR REPLACEMENT»(ref-220841-S42535080602006022100000) ), and recheck. If DTC P2108 is not indicated, replace the original throttle actuator control module (see «APP SENSOR REPLACEMENT»(ref-220841-S42535080602006022100000) ). NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the throttle body, the throttle actuator control module, and the ECM/PCM.

More articles — Electronic Throttle Control System (V6)