Intermittent Condition, Pcm/ecm Reprogramming - Gas, Powertrain Verification Test & Pre-Diagnostic Troubleshooting Procedure: Removal & Installation Dodge Durango III

SECTION 2 - ADDITIONAL PCM/TCM REPLACEMENT PROCEDURES

To continue, first determine the type of PCM/TCM in the vehicle, read and write down the required steps, and then proceed to the for additional information on completing the procedures. Refer to STEP-BY-STEP INSTRUCTIONS .

If an NGC3 or NGC4 PCM was replaced, perform the following additional steps and/or routines

1. PCM Replaced (if equipped with WCM)
2. Learn ETC (if equipped with ETC)
3. Check PCM VIN (if NOT equipped with WCM)
4. Check PCM Odometer
5. Quicklearn (if equipped with EATX)

If a GPEC PCM was replaced, perform the following additional steps and/or routines

1. If the vehicle is equipped with a CVT, verify that the TCM has the latest software calibration available.
2. PCM Replaced (if equipped with WCM)
3. Learn ETC
4. Check PCM Odometer
5. Check PCM VIN (if NOT equipped with WCM)
6. TCM Quicklearn (if equipped with EATX)

If a CVT TCM was replaced, perform the following additional steps and/or routines

1. Initialize CVT, see «Initialize CVT»(ref-466029-S42014547502012050200000)

If an EGS TCM was replaced, perform the following additional steps and/or routines

1. Initialize EGS, see «Initialize EGS»(ref-466029-S14825812092012050200000)

PCM Replaced

The vehicle PIN (Personal Identification Number) will be required to complete the routine. This information may be obtained in three ways

1. The original selling invoice
2. DealerCONNECT > Parts > Key Codes
3. Contacting the District Manager.

From the "Home" screen, select "ECU View"

1. Select "WCM"
2. Select "Misc. Functions"
3. Select "PCM Replaced" and follow the on screen instructions.
4. When complete, select "Finish"