Removing - refitting: fuel temperature sensor (DV6UC) Citroen Jumpy II

Tooling

Parts which must always be replaced

Location

(1) fuel temperature sensor

(2) low pressure fuel pipe

Removing

Disconnect the ancillaries battery

Remove the cabin air inlet manifold

Remove

• The engine style cover (according to equipment)
• The air filter box
• The air inlet duct
• The inlet air bypass unit (according to equipment)
• The inlet air metering unit

Disconnect and move aside the connector (at "a")

Uncouple and close; using the closers [0194-T]

• The pipe (at "b")
• The pipe (at "d")

Unclip the low pressure fuel pipe (2) (at "c")

Remove the clip (4) from the mounting (5)

Carefully release the union of the low pressure fuel pipe (2) between the mounting (5) and the air inlet pipe (3) (at "e")

Remove the fuel low pressure pipe (2) and fuel temperature sensor (1) assembly

Refitting

Remove the closers [0194-T]

Refit the fuel low pressure pipe (2) and fuel temperature sensor (1) assembly

Carefully pass the union of the low pressure fuel pipe (2) between the mounting (5) and the air inlet pipe (3) (at "e")

Refit the clip (4) (new)

Couple up

• The pipe (at "d")
• The pipe (at "b")

Clip the low pressure fuel pipe (2) (at "c") (replace if necessary)

Connect the connector (at "a")

Operate the manual priming pump several times to prime the fuel circuit

Refit

• The inlet air metering unit
• The air inlet duct
• The inlet air bypass unit (according to equipment)
• The air filter box
• The engine style cover (according to equipment)

Refit the cabin air inlet manifold

Reconnect the ancillaries battery