Home ReviewsRefund
Home/Chevrolet/Uplander/Chevrolet Uplander I (2004-2008)/Repair manual/Testing & Diagnostics/P0140 - Fast Pass Test
Contents Wiring diagrams Section: Testing & Diagnostics All sections

P0140 - Fast Pass Test Chevrolet Uplander I

Testing & Diagnostics ~140 words
  1. DTCs P0036, P0054, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0125, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0464, P0496, P2135 are not set.
  2. DTCs P0420 and P2A01 are not commanding fuel.
  3. The system voltage is between 9-18 volts.
  4. The scan tool special functions are not active.
  5. This vehicle uses the following 2 methods to enable and run this diagnostic: The Engine Run Time parameter is less than 90 seconds. OR A cold start condition has been detected, identified by the following conditions: The Start-Up ECT parameter is less than 35°C (95°F). The Start-Up intake air temperature (IAT) parameter is less than 35°C (95°F). The difference between the Start-Up ECT parameter and the Start-Up IAT parameter is less than 6°C (10.8°F).

More articles — Engine Controls - 3.9L - DTC P0011 to P0420