FASTENER TIGHTENING SPECIFICATIONS
| Component | Bolt Size | Nm |
|---|---|---|
| A/C Compressor | 25 | |
| Connecting Rod Bearing Cap 1 | 45 Nm +90° | |
| Dual Mass Flywheel 1 | 60 + 90° | |
| Pressure Relief Valve | 27 | |
| Sensor Wheel 1 | 10 +90° | |
| Vibration Damper 1 | 150 + 90° | |
| 1 Always replace | ||
Accessory Assembly Bracket Tightening Sequence
Mount the accessory assembly bracket and then mount the bolts -4-.
Tighten bolts in 3 stages in -1 to 5- sequence as follows
| Tighten bolts by hand.-- Tighten the bolts to 20 Nm.-- Tighten the bolts an additional 90°. |
Transmission Side Sealing Flange, Tightening Sequence
Tighten the bolts -1 through 8- in the sequence shown
1. Tighten the bolts hand-tight.
2. Tighten the bolts to 9 Nm.
Crankshaft, Tightening Sequence
Tighten the crankshaft bolts in the sequence -1 to 5-.
Tighten the bolts -1 through 10- and -arrows- hand-tight.
Tighten the bolts -1 through 10- to 65 Nm.
Tighten the bolts -1 through 10- 90° further using a rigid wrench.
Tighten the bolts -arrows- to 20 Nm.
Tighten the bolts -arrows- 90° further using a rigid wrench.