Installing engine block components
Note. Always use new seal washers and gaskets
Install
- thermostat housing (B52x4x)
- knock sensor (KS)
- flame trap
- the pipe screw for the water-heated crankcase ventilation.
| B5xx4x ........ Engine body, exposing |
|---|
| B6xx4x ........ Engine body, exposing |
If in doubt about the order of assembly see
Install the flywheel and carrier plate. See Crankshaft seal rear, replacing .
| B5xx4x ........ Tightening torque |
|---|
| B6xx4x ........ Tightening torque |
For the correct tightening torques see
The ignition coil alignment and the wiring routing follows the illustrations below.
B5xx4x
Scheme 481
B6xx4x
