Installing the bracket
Install the bracket on the cylinder block and chain housing using 6x M10 screws.
First tighten the screws for the bracket/cylinder block so that the bracket can moves slightly.
Then tighten the two screws to the bracket - chain housing alternately lightly.
Then tighten all the screws.
Install the screws for the fuel line clamp. Tighten.
Scheme 1376
Install the propeller shaft using the marking made earlier.
Check carefully that the mating surfaces on the propeller shaft and flange are clean. Install the 6x M8 screws and washers. Tighten. See Summary of tightening torques for specific components . Use counterhold 9997057 .
Install the 2x M8 screws to the propeller shaft center bearing. Tighten.