Home/Volvo/S80/Volvo S80 I (1998-2003)/Repair manual/Transmission - Removal and Installation
Manual sections Wiring diagrams
Repair manual

Transmission - Removal and Installation Volvo S80 I

Step-by-step instructions on "Transmission - Removal and Installation" for Volvo S80 I (1998–2003). Pick an article — removal, installation, adjustment and diagnostics with illustrations.

41subsections
41articles
57illustrations

Gearbox, removing

1 article

Disconnecting the battery lead

1 article

Removing splash guards

1 article

Removing the screws for the cable conduit and ground lead bracket on the sub-frame

1 article

Removing the nut for the lower ball joint/control arm

1 article

Removing the screws for the sub-frame support plates (both sides)

1 article

Removing the stub axle from the control arm

1 article

Removing the drive shaft from the stub axle (right-hand side)

1 article

Removing the cap for the drive shaft support bearing

1 article

Removing the drive shaft

1 article

Press up the sub-frame on the right-hand side

1 article

Removing the screw for the rear engine pad

1 article

Removing the rear engine mounting

1 article

Preparations for removing the stub axle on the left-hand side

1 article

Removing the left drive shaft from the gearbox

1 article

Lowering the sub-frame

1 article

Lowering the engine and gearbox

1 article

Removing the gearbox

1 article

Removing the transmission

1 article

Disconnect the battery lead

1 article

Install the lifting beam and the lifting hook on the engine lifting lugs

1 article

Preparatory work for removing the wheel spindle on the left-hand side

1 article

Transmission, automatic

1 article

Grease/oil

1 article

Constant velocity joint boot, grease quantity

1 article

Oil level, checking (-2003)

1 article

Preparing to check the oil level

1 article

Move the gear selector through all positions. Wait in each position for approximately 3 seconds

1 article

Top up with oil through the dipstick pipe

1 article

High level (overfilling)

1 article

Oil level, checking (2004-2006)

1 article

Conditions

1 article

Replacing the bevel gear/chain housing

1 article

Pay attention to the following when removing propeller shaft

1 article

Installing the bevel gear / chain housing

1 article

Installing the bracket

1 article

Installing the steering gear to the engine pad

1 article

Finishing

1 article

Replacing the carrier plate

1 article

Preparatory work

1 article

Removing the carrier plate

1 article