GENERATOR SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Brush Length | |||
| Standard | .413 in. (10.5 mm) | ||
| Limit (Minimum) | More Than .177 in. (4.5 mm) | ||
| Rotor | |||
| Resistance (1) | 2.3-2.7 ohms | ||
| Slip Ring Diameter | |||
| Standard | .559-.567 Inches (14.2-14.4 mm) | ||
| Minimum | .551 Inches (14.0 mm) | ||
| Generator Regulated Output | |||
| Amperage | |||
| Without Load | 10 Or Less Amps | ||
| With Load | 30 Or More Amps | ||
| Voltage | |||
| V6 model | 13.2-14.0 Volts | ||
| V8 model | 13.2-14.8 Volts | ||
| (1) Measured @ 68°F (20°C). | |||
| (1) | Measured @ 68°F (20°C). |
GENERATOR SPECIFICATIONS
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Fan Fluid Coupling Nut | 21 (29) | |
| Generator Mounting Bolt | 32 (43) | |
| Generator Pulley Nut | 81 (110) | |
| Power Steering Pump | ||
| Bolt | 32 (43) | |
| Nut | 32 (43) | |
| INCH Lbs. (N.m) | ||
| Battery Wire Terminal Nut | 87 (9.8) | |
| Bearing Retainer Bolt | 23 (2.6) | |
| Brush Holder | 16 (1.8) | |
| End Frame Bolt (1) | 51 (5.8) | |
| Fan Shroud Bolt | 44 (5.0) | |
| Generator Rear End Cover Nut | 41 (4.6) | |
| V-Bank Cover Nut | 66 (7.5) | |
| Wire Harness Bracket Bolt | 71 (8.0) | |
| (1) May also be refered to as coil assembly. | ||
| (1) | May also be refered to as coil assembly. |
TORQUE SPECIFICATIONS