OPERATION
For operation procedures, refer to the PC application help for Subaru Select Monitor.
For operation procedures, refer to the PC application help for Subaru Select Monitor.
Note. For details concerning DTCs, refer to List of Diagnostic Trouble Codes (DTC). Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .
For operation procedures, refer to the PC application help for Subaru Select Monitor.
Note. Clear the DTC stored in the airbag control module after repairing the airbag system.
When seat belt buckle switch malfunction occurs, or when seat belt buckle switch is replaced, check operation status of each sensor.
- On «Main Menu» display, select {Each System Check}.
- On «System Selection Menu» display, select {Airbag System}.
- On «Airbag System» display, select {Status Data}. The following table is for support data. DISPLAY CONTENTS REFERENCE Item Display Contents Seat position sensor LH - (2) Seat position sensor RH - (2) Seat belt buckle switch LH - (6) Seat belt buckle switch RH Fastened (3) /Not fastened (4) /Other (5) /lnitial Setting (1) /- (6) Passenger's airbag control status ON (7) /OFF (8) /lnitial Setting (1) (1) Displayed when it is initial (2) Seat position sensor not supported (3) Seat belt fastened (4) Seat belt not fastened (5) Displayed when data other than belt fastened or not fastened, such as breakdown, is input (6) Seat belt buckle switch not supported (7) Passenger's airbag operating state (8) Passenger's airbag non-operating state NOTE: For detailed operation procedures, refer to PC application help for Subaru Select Monitor.