Blower Resistor Replace Opel Antara I

Blower Resistor Replace

Remove

1. Disconnect the negative battery cable.
2. Remove the glove box lower panel cover. Refer to Instrument Compartment Replace .
3. Disconnect the electrical connector at the resistor.
4. Remove the mount screws from the resistor.
5. Remove the resistor from the heater/air distributor case by gently pulling the resistor downward.

Install

1. Install the new resistor into the heater/air distributor case with the screws.

Tighten

Tighten the blower motor resistor screws to 6 N•m (53 lb-in).

2. Connect the electrical connector at the resistor.
3. Connect the negative battery cable.
4. Confirm the proper performance of the blower.
5. Install the glove box lower panel cover. Refer to Instrument Compartment Replace .