Steering Angle Sensor Replace Opel Antara I



Steering Angle Sensor Replace

Remove

1. Disconnect the negative battery cable.
2. Remove the intermediate shaft from column shaft by removing the upper pinch bolt. Refer to Intermediate Shaft, Joint and Dash Seal Replace .
3. Disconnect the connector of steering angle sensor.
4. Move the steering angle sensor upward to remove its key from retaining bracket.

5. Remove the steering angle sensor by sliding out of retaining bracket and down the column shaft.

Install

1. Slide the steering angle sensor to the opening of retaining bracket.
2. Install the steering angle sensor on the groove of retaining bracket.
3. Connect the connector of steering angle sensor.
4. Connect the negative battery cable.
5. Perform the steering angle sensor centring after installing the steering angle sensor. Refer to Steering Angle Sensor Centring .