Remove
- 1. Disconnect battery negative lead • Release nut
- 2. Release airbag from steering wheel • Release 2x bolt (1)
- 3. Remove airbag from steering wheel • Disconnect harness connector (1) from airbag – Release clip (3) • Disconnect earth lead (2) for horn from airbag
- 4. Disconnect harness connector from airbag contact unit
- 5. Release steering wheel from steering column • Remove nut
- 6. Remove steering wheel from steering column • Use Puller KM-210-3 • Withdraw airbag harness through aperture in steering wheel
Note. Steering wheel should be in the straight ahead position before removing.
- 7. Remove cover (2) from rear of steering wheel • Release harness for remote control switch (4) from steering wheel – Release from clip • Remove 2x screw (1), 2x washer, then release 2x clip
- 8. Remove blanking cover from steering wheel • Remove screw, then release 2x locator from steering wheel
- 9. Remove remote control switch from steering wheel • Remove screw (3), then release 2x locator from steering wheel
Install
- 10. Install remote control switch (4) to new steering wheel • Secure 2x locator to steering wheel, then install screw (3)
- 11. Install blanking cover to steering wheel • Secure 2x locator to steering wheel, then install screw
- 12. Install cover (2) to rear of steering wheel • Secure 2x clip, then install 2x washer, 2x screw (1) • Secure harness for remote control switch to steering wheel – Secure to clip
- 13. Install steering wheel to steering column • Feed airbag harness through aperture in steering wheel • Install new nut 33 Nm
- 14. Connect harness connector to airbag contact unit
- 15. Install airbag to steering wheel • Connect earth lead (2) for horn to airbag • Connect harness connector (1) to airbag – Secure clip (3)
- 16. Secure airbag to steering wheel • Secure 2x bolt (1) 9 Nm
- 17. Connect battery negative lead
- 18. Program all volatile memories – see operation “Program Volatile Memories”