Home ReviewsRefund
Home/Nissan/Sentra/Nissan Sentra B15 (1998-2006)/Repair manual/Automatic Trans/Automatic Transaxle - RE4F04B: Removal & Installation
Contents Wiring diagrams Section: Automatic Trans All sections

Automatic Transaxle - RE4F04B: Removal & Installation Nissan Sentra B15

Automatic Trans 3 illustrations

Revolution Sensor Replacement

  1. Remove under cover.
  2. Remove revolution sensor from A/T.
  3. Reinstall any part removed. Always use new sealing parts.

Scheme 1357

Scheme 1357
Scheme 1357

Scheme 1358

Scheme 1358: Park/Neutral Position (PNP) Switch Adjustment
Scheme 1358: Park/Neutral Position (PNP) Switch Adjustment

Scheme 1359

Scheme 1359
Scheme 1359
  1. Remove control cable from manual shaft.
  2. Set manual shaft in N position.
  3. Loosen park/neutral position (PNP) switch fixing bolts.
  4. Insert pin into adjustment holes in both park/neutral position (PNP) switch and manual shaft as near vertical as possible.
  5. Reinstall any part removed.
  6. Check continuity of park/neutral position (PNP) switch. Refer to " «DIAGNOSTIC PROCEDURE»(ref-214137-S19165466812005123100000) ".

More articles — Automatic Transaxle - RE4F04B