Contents Section: Ignition Switch/steering Lock All sections

Ignition Switch: Other Mitsubishi Outlander II рестайлинг

Ignition Switch/steering Lock 1 illustration ~169 words

CHECK OF IGNITION KEY REMINDER WARNING FUNCTION (STEERING LOCK REMINDER TONE ALARM BY KOS)

  1. Close the driver's door, unlock the steering lock, and turn the key (for the vehicle with KOS, the emergency key is inversely inserted into the keyless operation key) to the LOCK (OFF) position (the key is being inserted). < Vehicles with WCM and vehicles with KOS (When using the emergency key) >
  2. Release the steering wheel lock with the driver's door closed, and turn the IG knob to the position other than the LOCK (OFF) position. < Vehicles with KOS (When not using the emergency key) >
  3. Change the driver's door state from closed to open.
  4. Check that the tone alarm sounds normally.
  5. If a malfunction is found, carry out the troubleshooting (Refer to «TROUBLE SYMPTOM CHART»(ref-394952-S13870247662011040900000) ).

KEY REMINDER SWITCH CONTINUITY CHECK

With the key reminder switch mounted to the vehicle, disconnect the key reminder switch connection connector, and then perform the continuity check.

Key statusTerminal numberNormal condition
Key removed2 - 3Continuity exists (2 ohms or less)
Key inserted2 - 3No continuity

KEY REMINDER SWITCH CONTINUITY CHECK

Scheme 10

Scheme 10