Manual sections
Repair manual

Active Stability Control System (Asc): Diagnosis Mitsubishi Outlander II рестайлинг

Step-by-step instructions on "Active Stability Control System (Asc): Diagnosis" for Mitsubishi Outlander II рестайлинг (2009–2013). Pick an article — removal, installation, adjustment and diagnostics with illustrations.

37subsections
37articles
50illustrations

ASC DIAGNOSTIC TROUBLE CODE DETECTION CONDITIONS

1 article

ASC DIAGNOSTIC TROUBLESHOOTING STRATEGY

1 article

ON-BOARD DIAGNOSTICS

1 article

HOW TO CONNECT THE SCAN TOOL (M.U.T.-III)

1 article

HOW TO READ AND ERASE DIAGNOSTIC TROUBLE CODES

1 article

HOW TO PERFORM ACTUATOR TEST

1 article

HOW TO DIAGNOSE THE CAN BUS LINE

1 article

DIAGNOSTIC FUNCTION

1 article

DIAGNOSTIC TROUBLE CODE CHART

1 article

DTC SET CONDITIONS

1 article

Current trouble

1 article

Past trouble

1 article

DIAGNOSIS

1 article

DTC C101C: Abnormality in FR wheel speed sensor signal

1 article

DTC C101F: Mutual monitoring of FR wheel speed sensor

1 article

DTC C102A: Mutual monitoring of RL wheel speed sensor

1 article

DTC C104B: Abnormality in FL wheel inlet valve system; DTC C104F: Abnormality in FR wheel inlet valve system; DTC C1053: Abnormality in RL wheel inlet valve system; DTC C1057: Abno

1 article

DTC C121D: Abnormality in brake fluid pressure sensor circuit

1 article

DTC C121E: Abnormality in brake fluid pressure sensor output signal

1 article

DTC C123C: Abnormality in G and yaw rate sensor [Abnormality in lateral G and yaw rate output value (incorrect installation)]

1 article

DTC C121A: Abnormality in steering wheel sensor initialization

1 article

COMMENTS ON TROUBLE SYMPTOM

1 article

SYMPTOM CHART

1 article

Inspection Procedure 1: Scan tool communication only with ABS/TCL/Skid control system is impossible

1 article

Inspection Procedure 4: ABS warning light does not illuminate when ignition switch is turned to the ON position (engine stopped)

1 article

Inspection Procedure 5: Brake warning light does not illuminate when the ignition switch is turned to ON position (engine stopped)

1 article

Inspection Procedure 6: ABS warning light stays ON after the engine is started

1 article

Inspection Procedure 7: ASC warning display stays ON after the engine is started

1 article

Inspection Procedure 10: After ASC OFF switch is turned OFF, TCL/Skid control system cannot be disabled

1 article

Inspection Procedure 12: ASC system does not operate or faulty ASC operate

1 article

Inspection Procedure 13: ASC-ECU power supply circuit system

1 article

Inspection Procedure 15: HSA (Hill Start Assist) does not work

1 article

Inspection Procedure 16: HSA (Hill Start Assist) works on a flat road

1 article

Inspection Procedure 17: The initial check sound of hydraulic unit is loud

1 article

COMMENT ON TROUBLE SYMPTOM

1 article

ACTUATOR TEST REFERENCE TABLE

1 article

WHEEL AND TIRE INSPECTION

1 article