REMOVAL AND INSTALLATION
| WARNING | Before removal of the air bag module, refer to SRS SERVICE PRECAUTIONS and AIR BAG MODULE (S) AND CLOCK SPRING . When removing and installing the steering wheel, do not let it bump against the air bag module. |
Scheme 270
Scheme 271
- Remove half of the front bumper assembling clips and bolts. NOTE: The Figure illustrates the procedures to remove the headlight assembly (LH).
- Slide the front bumper down to remove the headlight assembly.
<< A >> FOG LIGHT BULB REMOVAL
| CAUTION | Use the specified genuine part when replacing the bulb. Do not touch the glass portion of bulb with bare hand or dirty gloves. Should the glass portion be spoiled, remove the soil as soon as possible using alcohol or thinner and let it dry before mounting. |
Turn the fog light bulb left to remove it.
Scheme 272
Scheme 273
<< A >> SIDE TURN SIGNAL LIGHT REMOVAL
Use a special tool, etc. to remove the side turning signal light by pushing the fender forward, bending the hook, and then unclamping the thumb.
Scheme 274
>>A<< SIDE TURN SIGNAL LIGHT INSTALLATION
Clamp the thumb on the fender panel the assemble the side turn signal light.
Scheme 275
| WARNING | Before removing a seat equipped with the side air bag module, refer to SRS SERVICE PRECAUTIONS . |
Scheme 276
Note. Install each seat assembly mounting bolt in every installation location, then tighten to the specified torque.
Scheme 277
Refer to HEATER CONTROL ASSEMBLY AND BLOWER SWITCH ASSEMBLY .
