FASTENER TIGHTENING SPECIFICATIONS
| ITEMS | SPECIFICATIONS |
|---|---|
| Roll stopper bracket mounting bolt | 69 ± 10 N.m (51 ± 7 ft-lb) |
| Shift cable bracket mounting bolt | 19 ± 3 N.m (14 ± 2 ft-lb) |
| Select lever mounting bolt | 19 ± 3 N.m (14 ± 2 ft-lb) |
| Speedometer gear mounting bolt | 4 ± 1 N.m (35 ± 9 in-lb) |
| Backup light switch | 32 ± 2 N.m (24 ± 1 ft-lb) |
| Interlock plate bolt | 30 ± 3 N.m (22 ± 2 ft-lb) |
| Poppet spring | 32 ± 2 N.m (24 ± 1 ft-lb) |
| Control housing mounting bolt | 19 ± 3 N.m (14 ± 2 ft-lb) |
| Under cover mounting bolt | 7 ± 1 N.m (61 ± 9 in-lb) |
| Reverse idler gear shaft mounting bolt | 48 ± 6 N.m (35 ± 4 ft-lb) |
| Clutch housing-transaxle case mounting bolt | 44 ± 5 N.m (33 ± 4 ft-lb) |
| Front bearing retainer mounting bolt | 19 ± 3 N.m (14 ± 2 ft-lb) |
| Select lever mounting nut | 12 ± 1 N.m (104 ± 9 in-lb) |
| Stopper bracket mounting bolt | 22.3 ± 0.3 N.m (16.1 ± 0.2 ft-lb) |
| Clutch release bearing retainer mounting bolt | 9.8 ± 2 N.m (87 ± 17 in-lb) |
| Differential drive gear mounting bolt | 132 ± 5 N.m (98 ± 4 ft-lb) |
Fastener Tightening Specifications
GENERAL SPECIFICATION(S)
| ITEMS | SPECIFICATIONS | ||
|---|---|---|---|
| Model | F5M42-1-F7B | F5M42-1-F8B | |
| Applicable engine | 4G94 | ||
| Type | 5-speed transaxle floor shift | ||
| Gear ratio | 1st | 3.583 | |
| 2nd | 1.947 | ||
| 3rd | 1.379 | ||
| 4th | 1.030 | ||
| 5th | 0.767 | ||
| Reverse | 3.363 | ||
| Final reduction ratio | 3.722 | ||
| Speedometer gear ratio (driven/drive) | 30/36 | 31/36 | |
General Specifications Table
