DYNAMIC STABILITY CONTROL SENSOR INITIALIZATION PROCEDURE
| WARNING | If the DSC sensor initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM or SAS control module, make sure to perform the DSC sensor initialization procedure to insure proper DSC operation. |
Scheme 53
- Inspect the wheel alignment and the tire pressure. If there is any malfunction, adjust the applicable part.
- Position the vehicle on level ground.
- Switch the ignition to off.
- Connect the M-MDS (IDS) to DLC-2. (Scheme 53): Identifying Data Link Connector (DLC-2)
- After the vehicle is identified, select the following items from the initial screen of the IDS. Select "Chassis". Select "ABS/DSC". Select "Sensor Initialization".
- Perform the procedure according to the directions on the screen.
- Drive the vehicle.
- After 5 min or more of driving, verify that the DSC system is normal.
