KEY REGISTRATION (KEY OR KEY CYLINDER REPLACED)
Note. The key registration procedure of a new master key and new sub-key on this vehicle; when a new ignition cylinder and key set, and new lock cylinder set including key cylinder are installed, is described below.
- Remove the wireless and immobilizer module from the original master key. (Scheme 37)
- Making a new master key After replacing and installing new ignition cylinder, install the removed original modules into new 2 key housing as supply parts.
- Register the supplied new sub-key and/or master key by using a new master key. See ADDITIONAL SUB-KEY REGISTRATION and KEY CODE ERASURE.
- There are 2 ways for registration of an additional master key, one way is depressing the brake pedal and acceleration pedal and the other way is using the hand-held tester. When using the brake and accelerator pedal for additional master key registration, refer to flowchart. (Scheme 38) When using the hand-held tester for additional master key registration, refer to flowchart. (Scheme 39)
Scheme 37
Scheme 38
Scheme 39
REMOVAL & INSTALLATION
| WARNING | Vehicles are equipped with air bag supplemental restraint system. Before attempting any repairs involving steering column, instrument panel or related components, see SERVICE PRECAUTIONS and DISABLING & ACTIVATING AIR BAG SYSTEM in AIR BAG RESTRAINT SYSTEMS article. |
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Note. Removal and installation procedures are not available from manufacturer.