REMOVAL & INSTALLATION
| WARNING | Vehicles are equipped with air bag supplemental restraint system. Before attempting any repairs involving steering column, instrument panel or related components, see SERVICE PRECAUTIONS and DISABLING & ACTIVATING AIR BAG SYSTEM in AIR BAG RESTRAINT SYSTEMS article. |
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Removal
- Remove the screw from the wireless remote control key and then push the cover upwards.
- Remove the module from the key frame.
- Remove the 2 screws to take out the lid of the module.
- Take out the discharged battery and put a new battery with the positive side up.
Installation
| CAUTION | Do not replace the battery with wet hands. Water may cause unexpected rust. |
| CAUTION | Do not touch or move any components inside the transmitter, or it may interfere with proper operation. |
| CAUTION | Be careful not to bend the electrode of the battery insertion and that dust or oils do not adhere to the inside of the module. |
| CAUTION | Take care not to damage or bend the "O" ring when installing. |
Note. Take care not to lose the screws and "O" ring.
Note. Make sure the positive side and negative side of the battery should be faced correctly.
- Install the lid with 2 screws.
- Install the module into the key frame and secure the cover with the screw.
- When pushing any switch on the wireless key, make sure the indicator light comes on.
