Home ReviewsRefund
Home/Land Rover/Freelander/Land Rover Freelander L314 (2003-2006)/Repair manual/Mechanical/Assemble
Contents Wiring diagrams Section: Mechanical All sections

Assemble Land Rover Freelander L314

Mechanical ~182 words
  1. Clean cylinder block face and oil seal running surface on crankshaft, ensure bolt holes are clean and dry.
  2. Position oil seal protector, LRT-12-061 to crankshaft. (Схема №183)
  3. Position oil seal to crankshaft. CAUTION: Oil seal must be fitted dry.
  4. Fit new Patchlok bolts securing oil seal to cylinder block and using sequence shown, tighten to 8 Nm (6 ft. lbs.). (Схема №184)
  5. Remove oil seal protector LRT-12-061.
  6. Clean bolt holes in crankshaft using an old drive plate bolt with two saw cuts at an angle of 45° to the bolt shank.
  7. Clean drive plate and mating face of crankshaft.
  8. Position drive plate to crankshaft and fit but do not tighten new Patchlok bolts.
  9. Position LRT-12-161 and LRT-12-199 to crankshaft pulley to restrain crankshaft.
  10. Using sequence shown, tighten bolts: Stage 1 - 25 Nm (18 ft. lbs.) Stage 2 - 100 Nm (74 ft. lbs.)
  11. Remove special tool from crankshaft pulley, loosen bolt and remove LRT-12-161 from LRT-12-199
  12. Fit automatic gearbox. See «ENGINE & AUTOMATIC GEARBOX - FROM MODEL YEAR 2003»(ref-158807-S21698994502005011200000) or «ENGINE & AUTOMATIC GEARBOX - UP TO MODEL YEAR 2003»(ref-158807-S05704619712005011200000).

More articles — 2.5L V6