Battery: Other Honda S2000 AP1

Disconnection

Note. Some systems store data in memory that is lost when the battery is disconnected Do the following procedures before disconnecting the battery

1. Make sure you have the anti-theft code(s) for the audio and/or the navigation system (if equipped)
2. Make sure the ignition switch is in LOCK (0)
3. Disconnect and isolate the negative cable from the battery NOTE: Always disconnect the negative cable from the battery first
4. Disconnect the positive cable from the battery

Reconnection

Note. Some systems store data in memory that is lost when the battery is disconnected Do the following procedures before disconnecting the battery

Scheme 42

1. Clean the battery terminals.
2. Test the battery «BATTERY TEST»(ref-221385-S19013466022006022400000)
3. Reconnect the positive cable (A) to the battery (B) first, then reconnect the negative cable (C) to the battery NOTE: Always disconnect the negative cable from the battery first
4. Apply multipurpose grease to the terminals to prevent corrosion
5. Enter the anti-theft code(s) for the audio system and/or the navigation system (if equipped).
6. 2000-05 models : Do the ECM idle learn procedure

Note. The battery terminal disconnection/reconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ) must be done before and after doing this procedure. Some systems store data in memory that is lost when the battery is disconnected.

Scheme 43

1. Do the battery terminal disconnection procedure (see «DISCONNECTION»(ref-221385-S40144297672009111300000) )
2. Remove the two nuts (A) securing the battery setting plate, then remove the battery setting plate (B) and the battery (C)

Scheme 44

1. Install the battery (A), then install the battery setting plate (B)
2. Tighten the two nuts (C) equally until the battery is stable NOTE: Do not deform the battery setting plate by tightening the nuts too much
3. Do the battery terminal reconnection procedure (see «RECONNECTION»(ref-221385-S40426783402009111300000) ) NOTE: Make sure the positive terminal and the negative terminal are not reverse-connected