DTC P0111: IAT Sensor Circuit Range/ Performance Problem (2006 model); DTC P1116: ECT Sensor Circuit Range/ Performance Problem (2006 model) Honda Insight ZE1

Note. Before you troubleshoot, record all freeze data and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

1. Check for poor connections or loose terminals at the ECT sensor and the IAT sensor. Are the connections and terminals OK? YES - Go to step 2. NO - Repair the connections or terminals, then go to step 25 .
2. Start the engine, and let it idle for 10 minutes.
3. Check the ECT SENSOR in the DATA LIST with the HDS. Is about 129°F (54°C) or less, or 1.54 V or more indicated? YES - Replace the ECT sensor, then go to step 25 . NO - Go to step 4.
4. Turn the ignition switch OFF.
5. Remove the IAT sensor.
6. Allow the IAT sensor to cool to 77°F (25°C).
7. Note the ambient temperature.
8. Connect the IAT sensor to the 2P connector. But do not install the sensor on the intake air duct.
9. Turn the ignition switch ON (II).
10. Note the value of the IAT SENSOR quickly in the DATA LIST with the HDS.
11. Compare the IAT SENSOR and the ambient temperature. Does the IAT SENSOR differ 5.4°F (3°C) or more? YES - Replace the IAT sensor, then go to step 25 . NO - Go to step 12.
12. Disconnect the IAT sensor from the 2P connector.
13. Using a heat gun, below hot air on the IAT sensor for a few seconds. Do not apply the heat longer than a few seconds or you will damage the sensor.
14. Connect the IAT sensor to the 2P connector. Do not install it on the intake air duct.
15. Check the IAT SENSOR in the DATA LIST with the HDS. Does the IAT SENSOR change 82°F (28°C) or more? YES - Go to step 16. NO - Replace the IAT sensor, then go to step 25 .
16. Turn the ignition switch OFF.
17. Drain the coolant (see «COOLANT REPLACEMENT»(ref-219286-S08980614052006021300000) ).
18. Remove the ECT sensor.
19. Allow the ECT sensor to cool to 77°F (25°C).
20. Note the ambient temperature.
21. Connect the ECT sensor to the 2P connector. Do not install the sensor on the engine.
22. Turn the ignition switch ON (II).
23. Note the value of ECT SENSOR quickly in the DATA LIST with the HDS.
24. Compare the ECT SENSOR and the ambient temperature. Does the ECT SENSOR differ 5.4°F (3°C) or more? YES - Replace the ECT sensor, then go to step 25. NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the ECT sensor and the ECM.
25. Turn the ignition switch ON (II).
26. Reset the ECM with the HDS.
27. Do the ECM idle learn procedure (see «ECM IDLE LEARN PROCEDURE»(ref-219290-S07506924172006021300000) ).
28. Check for Temporary DTCs or DTCs with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P0111 and/or P1116 is indicated, check for poor connections or loose terminals at the ECT sensor, or the IAT sensor and the ECM, then go to step 1 . If any other Temporary DTCs or DTCs are indicated, go to the indicated «DTC TROUBLESHOOTING»(ref-219289-S32747860742006021300000) NO - Troubleshooting is complete.