Engine System - General Information: Specifications Ford Escape III

Material Specifications

MATERIAL SPECIFICATIONS

Torque Specifications

TORQUE SPECIFICATIONS

Note. When repairing engines, all parts must be contamination free. If contamination/foreign material is present when repairing an engine, premature engine failure may occur.

Note. Specifications show the expected minimum or maximum condition. Refer to the appropriate engine service information for the procedure.

Note. If a component fails to meet the specifications, it is necessary to refinish it or install a new component. Wear limits are provided as an aid to determine if the component can be refinished. A new component must be installed when any component fails to meet specifications and cannot be refinished.

Note. This information contains information, steps and procedures that may not be specific to this engine.

This information covers general procedures and diagnosis and testing of the engine system, except for exhaust emission control devices, which are covered in the INTRODUCTION - GAS .

The engine incorporates the following features: Refer to the appropriate engine service information for the procedure.

1. Crankcase ventilation or breather system
2. Exhaust emission control system
3. Evaporative Emission (EVAP) control system

Some engines incorporate a fail-safe cooling system. Refer to the appropriate engine cooling article for the procedure.

The engine, fuel system, ignition system, emissions system and exhaust system all affect exhaust emission levels and must be maintained according to the maintenance schedule. Refer to the scheduled Maintenance guide, refer to the MAINTENANCE SCHEDULE article.

Correct engine identification is required to order parts.

For complete vehicle and engine identification codes, refer to VIN - IDENTIFICATION CODES .

SPECIAL TOOLS 12 Volt Master UV Diagnostic Inspection Kit 164-R0756 or equivalent (Leak Detector) Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent EngineEAR 107-R2103 or equivalent EngineEAR/ChassisEAR 107-R2102 or equivalent Oil Pressure Gauge 303-088 (T73L-6600-A) Vacuum/Pressure Tester 164-R0253 or equivalent Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool

Scheme 481

Scheme 482

Scheme 483

Scheme 484

Scheme 485

Scheme 486

Scheme 487

MATERIAL SPECIFICATIONS

There are 2 diagnostic paths that can be followed depending on the type of engine concern. Carry out INSPECTION AND VERIFICATION - ENGINE PERFORMANCE or INSPECTION AND VERIFICATION - NVH .

See also:
• MAINTENANCE SCHEDULE
• JACKING & LIFTING