REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer may lose memory data. Driveability concerns may exist until computer systems have completed a relearn cycle. Before disconnecting battery, see COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION. |
Note. For CD4E transaxle mechanical component removal and installation information, see appropriate OVERHAUL article.
Disconnect negative battery cable. On Cougar, PCM is located in right rear of engine compartment, mounted on cowl. see scheme 3 On Escape and Tribute, PCM is located in center rear of engine compartment. Remove any component necessary to gain access to PCM. Loosen PCM connector retaining bolt (if equipped). Unplug harness connector from PCM. Remove 2 PCM mounting bolts. Remove PCM cover and PCM. To install, reverse removal procedure. Program PCM once installation is completed. See PROGRAMMING.
