Engine Ignition System - 3.5L: Removal & Installation Ford Edge I рестайлинг

Removal and Installation

RH side

Scheme 1

1. Remove the upper intake manifold. For additional information, refer to «ENGINE - 3.5L»(ref-494554) or «ENGINE MECHANICAL - 3.7L»(ref-494555) . Both sides
2. Disconnect the 6 ignition coil-on-plug electrical connectors.
3. Remove the 6 bolts and the 6 ignition coil-on-plugs. To install, tighten to 7 Nm (62 lb-in).
4. Inspect the coil seals for rips, nicks or tears. Remove and discard any damaged coil seals. To install, slide the new coil seal onto the coil until it is fully seated at the top of the coil.
5. To install, reverse the removal procedure. Apply a small amount of dielectric grease to the inside of the ignition coil-on-plug boots before attaching to the spark plugs.

Scheme 2

1. Remove the 6 ignition coil-on-plugs. For additional information, refer to «IGNITION COIL-ON-PLUG»(ref-494612-S29220305462012081400000) .
2. Remove the 6 spark plugs. To install, tighten to 15 Nm (133 lb-in).
3. Inspect the 6 spark plugs. For additional information, refer to «ENGINE SYSTEM - GENERAL INFORMATION»(ref-494566) .
4. To install, reverse the removal procedure. Adjust the spark plug gap as necessary.