Power Windows: Other Dodge Stratus I

POWER CIRCUIT

1. Remove driver's door trim panel. See «DOOR TRIM PANEL»(ref-123837-S41528678482001092700000) under REMOVAL & INSTALLATION. Disconnect driver's power window switch connector. Turn ignition on.
2. Measure voltage between ground and terminal No. 1 (Tan wire) at power window wiring harness connector. (Scheme 4) If battery voltage is present, go to next step. If battery voltage is not present, check for an open circuit between ignition switch and power window switch connector.
3. Turn ignition off. Check for continuity between ground and terminal No. 10 (Black wire) at window switch wiring harness connector. If continuity exists, ground circuit is okay. If continuity does not exist, repair open Black wire to ground.

Scheme 4

POWER WINDOW MOTOR