Starting System: Removal & Installation Chrysler Voyager IV

INSTALLATION - 2.4L

1. Place starter in position on vehicle.
2. Install the lower bolts to hold starter to transaxle bellhousing.
3. Install the upper bolt and ground wire (Схема №10)
4. Place solenoid and B+ wires in position on starter terminals (Схема №9)
5. Install nut to hold B+ wire to terminal.
6. Connect solenoid wire connector onto terminal.
7. Connect battery negative cable.
8. Verify starter operation.

INSTALLATION - 3.3/3.8L

1. Place starter spacer in position on transaxle bellhousing, flange toward flywheel.
2. Place starter in position on bellhousing.
3. Install bolts and ground wire (Схема №10) to hold starter to transaxle bellhousing.
4. Connect solenoid connector into starter.
5. Install nut to hold B+ terminal to starter solenoid.
6. Lower vehicle.
7. Connect battery negative cable.
8. Verify starter operation.