Home/Chrysler/LHS/Chrysler LHS II (1998-2001)/Repair manual/Mechanical/Removal (Left): Overview

Contents

Wiring diagrams Section: Mechanical

Engine Identification

Valve Clearance Adjustment

Camshaft Sprocket Timing Procedure

Trouble Shooting

Removal & Installation

Fuel Pressure Release

Releasing Fuel Pressure

Removal (Upper)

Removal (Right)

Removal (Front)

Removal (Rear)

Installation (Front)

Cylinder Head

Valve Springs

Valve Guides

Valve Seat

Valves

Piston & Rod Assembly

Fitting Pistons

Piston Rings

Rod Bearings

Crankshaft & Main Bearings

Cylinder Block

Engine Lubrication System

Crankcase Capacity

Oil Pressure

Removal & Disassembly

Reassembly & Installation

Torque Specifications

General Specifications (3.2L)

General Specifications (3.5L)

Crankshaft, Main Bearings & Connecting Rod Bearings Specifications

Connecting Rods Specifications

Pistons, Piston Pins & Piston Rings Specifications

Cylinder Block Specifications

Engine Valves & Valve Springs Specifications

Cylinder Head Specifications

Camshaft Specifications

All sections

Removal (Left): Overview Chrysler LHS II

Mechanical

Disconnect negative battery cable from remote jumper terminal located at right strut tower. Raise and support vehicle. Apply penetrating oil and loosen band clamps at resonator connector. Support exhaust system with jack stand. Remove rubber isolators and exhaust system. Loosen catalytic converter pipe support bolt at transaxle mount.
Lower vehicle. Remove and discard "V" band clamp at exhaust manifold connector. Remove electrical harness connector bracket. Disconnect O2 sensor connector and remove sensor. Remove heat shield bolts and heat shield. Remove exhaust manifold bolts and exhaust manifold.