Home/Chrysler/Crossfire/Chrysler Crossfire I (2003-2007)/Repair manual/Mechanical/Installation - Right Side: Overview

Contents

Wiring diagrams Section: Mechanical

Engine Diagnosis - Introduction

Diagnosis and Testing - Engine Diagnosis - Mechanical

Engine Diagnosis - Performance

Diagnosis and Testing - Cylinder Compression Pressure Test

Diagnosis and Testing - Cylinder Combustion Pressure Leakage Test

Hydrostatic Locked Engine

Standard Procedure - Repair of Damaged or Worn Threads

Standard Procedure - Form-In-Place Gaskets and Sealers

Sealer Application

Standard Procedure - Engine Gasket Surface Preparation

Standard Procedure - Measuring Bearing Clearance Using Plastigage(r)

Specifications - Engine

Specifications - Torque

Diagnosis and Testing - Cylinder Head Gasket

Cylinder-To-Cylinder Leakage Test

Cylinder-To-Water Jacket Leakage Test

Visual Test Method

Cooling System Tester Method

Chemical Test Method

Engine Block

Cylinder Bore

Connecting Rod Bolts

Connecting Rod

Piston Pin

Piston

Installation - Left

Engine Oil Leak Inspection

Inspection for Rear Seal Area Leaks

Engine Oil Level Check

Standard Procedure - Engine Oil and Filter Change

Used Engine Oil Disposal

Diagnosis and Testing - Intake Manifold Leaks

Left Side

All sections

Installation - Right Side: Overview Chrysler Crossfire I

Mechanical

Position the manifold (2) and gaskets (1) on the cylinder head.
Install the manifold nuts (3). Tighten to 35 N.m (26 ft. lbs.).
Install the right side catalytic converter «(Refer to EXHAUST SYSTEM/CATALYTIC CONVERTER - INSTALLATION)»(ref-250610-S20258764272007031500000) .
Install the lower splash shield and screws (1). Tighten to 5 N.m (44 in. lbs.).
Lower the vehicle.
Install the air cleaner «(Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - REMOVAL)»(ref-250615-S26276682392007031500000) .
Connect the negative battery cable.
Start the engine and check for exhaust leaks.