Home ReviewsRefund
Home/Chevrolet/Uplander/Chevrolet Uplander I (2004-2008)/Repair manual/Communication Devices/Programming and Setup - All Systems: Diagnosis
Contents Wiring diagrams Section: Communication Devices All sections

Programming and Setup - All Systems: Diagnosis Chevrolet Uplander I

Communication Devices

Sensing and Diagnostic Module (SDM) Replacement

If the sensing and diagnostic module (SDM) is replaced, the following procedures must be performed

  1. BCM Reprogramming-Refer to «Body Control Module (BCM) Programming/RPO Configuration»(ref-241672-S41746577302006081100000) in Computer/Integrating Systems for replacement, setup and programming.
  2. Theft Learn-Refer to «Programming Theft Deterrent System Components»(ref-241694-S25732580982006081100000) in Theft Deterrent.

Inflatable Restraint Sensing and Diagnostic Module Programming and Setup

IMPORTANTThe air bag indicator light may remain ON after the body control module (BCM) or sensing and diagnostic module (SDM) is replaced and during the programming procedure for the BCM until after the procedure is completed and the ignition key is cycled OFF and ON.

If the SDM is replaced you must perform the BCM reprogramming procedure in order for the BCM to relearn the new SDM ID. Refer to Body Control Module (BCM) Programming/RPO Configuration .

More articles — Programming and Setup - All Systems