ADJUSTMENTS
| WARNING | Vehicle is equipped with Supplemental Inflatable Restraint (SIR) system. When servicing vehicle, use care to avoid accidental air bag deployment. SIR system-related components are located in various locations throughout interior and exterior of vehicle, depending on application. Do not use electrical test equipment on or near these circuits. If necessary, deactivate SIR system before servicing components. See AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION. |
Adjustment
- Install the band apply pin and the band apply pin tool. Install the servo cover retaining ring to secure the tool. (Схема №103)
- Apply 98 INCH lbs. (11 N.m) torque. If the White line appears in the gauge slot, the pin length is correct. (Схема №104)
- If the White line is not seen in the slot, replace the pin using the following pin identification: One groove, pin length 2.59-2.60" (65.82-66.12 mm). Two grooves, pin length 2.65-2.66" (67.23-67.53 mm). No grooves, pin length 2.70-2.71" (68.64-68.94 mm).
- Remove the pin and the band apply pin tool.
- Check the 2nd apply piston and the housing dimension. Measure the piston dimension. Measure the housing dimension. (Схема №105)
- Check the table for the transmission and piston/housing specifications.