Home ReviewsRefund
Home/Cadillac/STS/Cadillac STS I facelift (2007-2011)/Repair manual/Communication Devices/Programming and Setup - All Systems: Adjustments
Contents Wiring diagrams Section: Communication Devices All sections

Programming and Setup - All Systems: Adjustments Cadillac STS I facelift

Communication Devices

BPP Sensor Calibration

This procedure needs to performed whenever IPM or BPP sensor was replaced. Refer to Brake Pedal Position Sensor Calibration .

IMPORTANTAfter setup, perform the following to avoid future misdiagnosis
  1. Turn the ignition OFF for 10 seconds.
  2. Connect the scan tool to the data link connector (DLC).
  3. Turn the ignition ON, with the engine OFF.
  4. Use the scan tool in order to retrieve history DTCs from all modules.
  5. Clear all history DTCs.

More articles — Programming and Setup - All Systems