Removal
- To catch leaking brake fluid, place sufficient lint free cloths in area of plenum chamber, engine and transmission. Install bleeder hose and bleeder bottle to the front left brake caliper bleeder screw and open bleeder screw. Operate brake pedal until sufficient amount of brake fluid has been pumped out for the brake fluid level in the brake fluid reservoir to sink below the clutch master cylinder supply hose (if equipped). Close front left bleeder screw.
- Disconnect and clamp clutch master cylinder supply hose (if equipped) and seal with a plug. Disconnect brake fluid level warning indicator sensor harness connector. Remove reservoir retaining bolt. Remove brake fluid reservoir. To do this press down the locking tab on the reservoir and at the same time pull the brake fluid reservoir out of the sealing plugs.
- Disconnect brake lines on brake master cylinder and seal brake lines and threaded holes with plugs from repair kit Part No. 1H0 698 311 A. Remove brake master cylinder nuts. (Scheme 24) Carefully remove brake master cylinder from brake booster unit.
