Installing
Install in reverse order of removal, noting the following
| CAUTION | Before installing the ribbed belt, ensure that all subassemblies (generator, a/c compressor etc.) are securely mounted and turn freely. When installing belt, ensure correct seating in the belt pulleys! Reinstall all hose clamps, harness retainers and replace all removed cable ties as originally installed in production. |
Scheme 44
- Note running direction of ribbed belt as previously marked and route as illustrated.
- Generator (GEN)
- Ribbed belt
- Power steering pump
- Air conditioner compressor
- Crankshaft
- Tensioning roller
- Reconnect battery. Required steps «Reconnecting»(/audi/a4/b6-2000-2006/remont/cruise-control-systems/#electrical-equipment__reconnecting) .
- Start engine and check belt running.
Tightening torques
| Component - fastener | Nm | |
|---|---|---|
| M8 | 22 | |
| Generator to engine bracket - bolts | M10 | 45 |
| Terminal 30/B+ to generator - nut | 16 | |
| Bracket for refrigerant line to sump - bolt | 10 | |
| Bracket for starter wire to engine console - bolt | 10 | |