Home ReviewsRefund
Home/Audi/A4/Audi A4 B6 (2000-2006)/Repair manual/3.0l 6-cyl 5v Engine Controls - Fuel Injection & Ignition, Engine Code(s): Avk, Bgn/Diagnostic Trouble Code (DTC) memory, erasing
Contents Wiring diagrams Section: 3.0l 6-cyl 5v Engine Controls - Fuel Injection & Ignition, Engine Code(s): Avk, Bgn All sections

Diagnostic Trouble Code (DTC) memory, erasing Audi A4 B6

3.0l 6-cyl 5v Engine Controls - Fuel Injection & Ignition, Engine Code(s): Avk, Bgn 1 illustration ~182 words

Diagnostic Trouble Code (DTC) memory, erasing

Note. If it is not possible to erase DTC memory, check it once again and remedy malfunctions.

Requirements

  1. DTC memory checked. Refer to «Diagnostic Trouble Code (DTC) memory, checking»(/audi/a4/b6-2000-2006/remont/cooling-fan/#30l-6-cyl-5v-engine-controls-fuel-injection-ignition-engine-codes-avk-bgn__diagnostic-trouble-code-dtc-memory-checking) .
  2. All malfunctions repaired.

After DTC memory has been successfully checked

Display on VAS5051

  1. Under -1- select diagnostic function "05 - Erase DTC memory".

Scheme 459

Scheme 459
Scheme 459

Display on VAS5051

No display (before erasing)

or

DTC memory erased

Note. The following message appears in display zone -1-: "DTC memory not yet checked", if the operational sequence was not adhered to exactly. If the DTC memory has been checked beforehand, the DTC memory can only be erased.

Note. Should the function be carried out?

Will be erased!

  1. Press "OK" button in display -2-.
  2. Exit function "05 - Erase DTC memory" by pressing <-- button.
  3. Check DTC memory again after repair work and erase it if necessary.

Note. This erases DTCs that have been stored while the malfunction was being fixed, for example, malfunctions that have arisen as a result of connectors being detached.